Pink Whisper - Matte Nagelpuder
- €13,43
- €17
- save €3,57
Dieser weiche, hellrosa, matte Farbton hat einen Hauch von Pfirsich und ist perfekt für alle, die weiche und feminine Farbtöne lieben.
Unsere Nagelpuder werden mit einem Pinsel auf die Nägel aufgetragen, um in wenigen Minuten erstaunliche Ergebnisse zu erzielen. Unsere 16-freie Formulierung bedeutet auch, dass Sie Ihre Nägel dabei nicht beschädigen, da sie keine schädlichen Chemikalien enthält, die in den meisten Nagelprodukten enthalten sind. Kombinieren Sie dieses Nagelpuder mit unseren Mineral Bond Nagelkits, um erstaunliche Ergebnisse in Salonqualität zu erzielen, aber bequem zu Hause.
Gewicht: 1,5 g
-
4 payments of €3,35
Get started with the easiest nail system you will ever use
Choose Your Set HereTitanium Dioxide (CI 77891), May Contain +/- Manganese Violet (CI 77742), FD&C Blue 1 (CI 42090), FD&C Yellow 5 (CI 19140), FD&C Red 40 (CI 16035), D&C Green 5 (CI 61570), Iron Oxides (CI 77499)
Step 1: Prep Nails as per our User Guide.
Step 2: Apply a fine coating of Base Coat and cure under an LED lamp for 2 minutes. Ensure the powder in your pot is not a solid mass. Break up with 3 in 1 tool or similar
Step 3: Using your Mineral Bond applicator dab into powder to get coverage on your applicator.
Step 4: Dab colour by pressing down onto the nail (do not rub; just tap up and down over the surface of the base coat. Continue to dip your applicator in the powder pot as required. Continue to apply powder by dabbing until full coverage is obtained. Please note, that it will not look even at this stage.
Step 5: Once the nail is covered, it is important to remove excess powder. To obtain a smooth finish, lightly dust powder from base to tip, base to tip, removing excess powder.
Step 6: This motion should be continued until all white areas of the nail are no longer seen. You will see this slowly happening. You are not rubbing powder off, just removing excess you should not feel any resistance or stickiness under the applicator, if you do you’ve gone too far.
Step 7: Apply a fine coating of the Top coat and set it under an LED lamp for 2 mins.
